Contact Us Get a Quote
Rubber molding press with operator control panel on the Corry Rubber production floor

Molding

Corry Rubber molds elastomer parts by every major process, injection, injection-transfer, transfer, and compression, all on one block, so the method is matched to the part rather than the part to the method.

Molding press & controls · Corry, PA USA

Molding processes we run

  • Injection molding, computer-controlled, fully automated presses for high-volume, repeatable parts
  • Injection-transfer molding, for bonded and insert parts that need precise fill and flash control
  • Transfer molding, for rubber-to-metal bonded parts and high-cavitation molds where the rubber has to travel a long way
  • Compression molding, for large parts, low-to-moderate volumes, and premium compounds

Which process fits your part

We run all three, so we have no reason to steer you toward one. The short version: injection earns its tooling cost at volume, compression is the cheapest way into a large or low-volume part, and transfer is usually the answer when metal inserts are involved.

InjectionTransferCompression
Tooling costHighestMiddleLowest
Cycle timeFastestMiddleSlowest
Fine detailBestGoodLimited
Metal insertsWorkableBestSimple only
Material scrapLowestPot and sprueLow, charge is weighed
Volume fitHighModerateLow to moderate