Contact Us Get a Quote
Compound mixing floor at Corry Rubber, with pallets of raw elastomer and processing equipment

Custom Compounding

We develop custom elastomer formulations in-house and test them against any physical property your part depends on in our own ISO/IEC 17025:2017 accredited lab, then mix them on our own line. Most molders can do none of the three.

Compound mixing floor · Corry, PA USA

Why we formulate instead of buying

A molder without compound development can only pick from what a supplier already sells. When the shortlist does not hold your temperature, your fluid, or your spring rate, the answer you get is the closest stock compound and a hope, or a development timeline measured in months. We formulate in-house instead, for our own molding or for other manufacturers, to whatever specification the part needs and on a far shorter timeline. The recipe is ours to write, so the material is designed around the part rather than the part around the material.

Send a target specification, a competitor's datasheet, or a worn part off the machine. Our compounders will develop a formulation to hit it, and the engineers who run the verification tests are a few minutes away on the same block, so a miss is re-formulated and re-tested in a day.

Developing the formulation

Every lever in the recipe is ours, which is what makes a property target achievable rather than aspirational:

  • Polymer selection and blending for the service the part actually sees
  • Filler type and loading, which set hardness, modulus, and abrasion behavior
  • Cure system, sulfur or peroxide, chosen for heat and compression-set life
  • Plasticizers and process aids for low-temperature flexibility and flow
  • Protective systems for ozone, weather, and oxidative aging

Verifying it against real properties

A formulation is only a claim until it is measured. We test to the ASTM methods your specification names, in our own accredited lab, on the batch that will actually run:

  • Hardness, tensile, elongation, and modulus
  • Compression set and stress relaxation, which decide whether a seal is still sealing in year five
  • Dynamic spring rate and damping for vibration and shock parts
  • Heat aging and fluid immersion at your service temperature, in your media
  • Cure characterization by rheometer, batch against baseline

Because the lab is accredited, that data is defensible on a customer submission rather than something we simply assert. And because it is our lab, an iteration costs a day instead of a shipping cycle to an outside house.

Mixing it ourselves

The approved formulation is mixed on our own line, so the material in your part is made by the people who developed it. Nothing proprietary, your specification, your formulation, or your results, travels to a third party for any of it.

Why it differentiates us

Formulation, verification, and mixing on one block means the property data on your submission came from the compound that shipped, the person who can change the recipe works down the hall from the person who ran the test, and no part of the loop waits on a vendor. A molder buying compound in cannot offer any of that.

Open the Compound Finder